";s:4:"text";s:3727:" Grandfather clock weights are the engine driving the timing mechanism. It depends on the clock.
Its normal practice to hang the heaviest weight on the striking side which is the left side on an antique longcase/grandfather clock but occasionally there is an exception to this rule. "An antique grandfather clock is a friend and companion for life." 1.Stand the case in the position that you wish your clock to be in.
Being off level is the most common reason for the pendulum to be blocked during its swing. If your clock is running slow, raise the bob. Some older grandfather clocks will run just fine slightly out of level once the movement has been adjusted. Grandfather Clock Repair ... Make sure the grandfather clock is level. 11 Adjust the time and speed of your grandfather clock. The newer grandfather clocks need to be level …
Most cases are fairly well balanced, but when people insist on placing them on carpet, they can sink into the carpet and tilt forward.
This is not true for the newer grandfather clocks. 10 Adjust and calibrate your grandfather clock using the most advanced electronic equipment. If you clock is running fast, lower the bob. Adjust the leveling of the platform.
Then adjust the bob up, or down, to change the pendulums effective length. If the swing is correct this problem will not resurface. After twenty-four hours, record how many minutes your clock is off. Install your delicate timepiece on flat stable flooring – a grandfather clock may not operate properly unless it is well balanced, so you need to make any necessary adjustments to ensure the base of the clock is perfectly level; Test this by observing the swing of the pendulum. All clocks are meant to be level and in beat from side to side, but not all clocks are meant to be perfectly level from front to back. Place a level alongside the Grandfather Clock cabinet from front to back and side to side, adjusting the levelers until level. Check the platform where the grandfather clock has been stationed.
First synchronize your clock with an accurate time source - like a digital clock.
I normally tilt a grandfather clock backwards just a bit (less than a 1/2 inch) for one reason; front-heavy cases and the risk of toppling over. Clocks have three weights. Power is transmitted from the mainspring, through the gears to the anchor pin, to the fork, and down the suspension spring to the bottom block, to act on the pendulum with just enough force to keep it moving once set in motion. It may be necessary to periodically check your cabinet after initial set-up, (especially if the Grandfather Clock is on carpet), as it might settle after original leveling. Some clocks rest on carpeting, while others are positioned on hardwood or tile floors.
9 Re-level the grandfather clock’s case. They must be installed in their correct order. Even on wobbly wood floors, this can be a problem. Step 6 – Check the Level. 12 Make any additional fine adjustments. If there is a skirting board at floor level, it may be necessary to fix to the back of the case a similar thickness piece of wood so that the case will stand up straight and not lean backwards. If a clock is not level side to side and front to back, (or close) the bob may hit the case.
Usually constructed of solid wood and containing a brass movement and heavy weights, a grandfather clock requires a solid floor on which to sit.
A grandfather clock is one of the more majestic timepieces found in a home. Drop weights to their lowest level by not winding the clock or advance the minute hand until the weights are at the bottom of the case.